Figure not to scale

C-UAS · Boulder, Colorado

Drone detection at the front line.

Front-line units get little warning of small drones that emit no radio signal. Baseline Quantum is building a radar network that gives them real-time tracks on those drones, so they can decide and engage in time.

The problem

RF-silent drones are invisible at the front line.

Most U.S. Army air and missile defense radars sit tens of kilometers behind the front line, guarding airfields, command posts and other critical assets. From 40 km back, Earth's curvature alone hides anything below about 60 m at the front line, and hills and tree lines hide more.

01 / The gap

The sensors at the front miss them.

Most RF detectors listen for a drone's radio link and match it against a library of known signals. Fiber-optic drones, and drones flying on autonomy, can be RF-silent, and remote-controlled drones can use non-standard frequencies to evade the library. Even when these systems detect a drone, they give only a rough bearing, not a track precise enough to cue an interceptor.

02 / Our approach

We give the front line its own drone detection.

Small, low-cost active radar nodes go along the front line. They network together to detect and track drones as one system.

03 / Hard to find

The enemy can find only the active nodes.

Every node is the same. A few run active and light the sky. The rest listen only and send no radar signal, so enemy electromagnetic warfare has little to find. The active nodes are low-power, and cheap decoys that mimic them can add more. The enemy sees a field of small signals and cannot tell which ones matter.

04 / Attritable

Lose an active node. Keep detecting.

The network is redundant. When the enemy strikes an active node, a listen-only node can switch to active, and the rest keep tracking. A lost node is cheap to replace.

05 / Terrain

See around obstacles.

One radar cannot see behind a hill or a tree line. Nodes placed around an obstacle look in from several angles and cover the ground a single radar leaves blind.

06 / Kill chain integration

Tracks your unit can act on.

The system fuses what every node sees into one 3-D track per drone. It is designed to feed the command-and-control (C2) systems the Army runs, such as FAAD C2, Lattice and Maven Smart System. The brigade, or whichever unit holds engagement authority, then decides and picks the effect: a kinetic interceptor, directed energy or electromagnetic attack (jamming).

Hardware

The node

Our engineering model, now in design, is one sealed X-band radar. A soldier carries it in a pack, sets it on a tripod or the ground, and runs it from the Army’s standard radio battery. It watches a 90° sector with no moving parts. Tracks go by cable to the soldier’s TAK device and out over the unit’s own radios.

123456
  1. 1Transmit column
  2. 2Receive array
  3. 3Sealed housing, no fan
  4. 4BB-2590 battery
  5. 5Tripod
  6. 6Cable to the soldier's TAK device

Engineering model · figure not to scale

Design targets

Radar
X-band FMCW. Detection only.
Coverage
A 90° sector per node, with no moving parts. Four nodes cover 360°.
Tracks
Range and bearing to about 2° from one node, updated every 2 seconds. Two or more nodes add height.
Range
Per node. Mavic-size quadcopter (Group 1): 2.5 km. A 249 g drone: 1.2 km. Group 2: 5 km.
Size
Sealed unit, 28 × 25 × 8 cm.
Weight
About 6 kg with one BB-2590 battery, 4.5 kg without.
Power
One BB-2590 battery: about 3 hours transmitting, or about 5 hours as a listen-only node in a network. Also runs on 12–32 V DC or USB-C power; listen-only nodes can run on power over Ethernet.
Setup
One button, no survey: heading and level come from the onboard navigation sensor. Set up in about 3 minutes, pack up in 2.
Outputs
Cursor-on-Target to TAK. Lattice and SAPIENT interfaces in development. MIL-DTL-38999 connectors for power, Ethernet and USB-C. The node carries no radio of its own.
Emissions
Transmits only when the operator wants it to; an emission-control switch stops it. Listen-only nodes radiate nothing.
Environment
Sealed, no fan. Qualification targets: MIL-STD-810H (tailored), MIL-STD-461G, −32 to +49 °C operating.

These are targets for the X-band engineering model. Weight and battery life are estimates from a parts-level design budget. None is measured at X-band yet. Our low-power testbed tracked a 249 g DJI Mini to 115 m, where the drone’s 120 m altitude ceiling, not the radar, ended the test.

Fielding

Carried, or fixed in place

The same head and software serve both. A unit takes the man-pack to the front line; a fixed site mounts four or more heads and leaves them running.

Carried

Man-pack

One soldier carries the node. At a halt, set it down, look at the sky for a few minutes, pack it up and move. It is on the air for minutes, not hours.

Mount
Tripod or the ground
Power
One BB-2590 battery
Network
A cable to the soldier's TAK device, then the unit's own radios
Coverage
A 90° sector. Tracks from neighboring squads' nodes appear on the same TAK map; merging them into one track per drone is in development

Fixed in place

Fixed site

Heads on masts or roofs watch a command post, an airfield or a stadium around the clock. Four heads cover 360°. Extra listen-only heads give every bearing a second receiver and radiate nothing.

Mount
Mast or roof; four heads for 360°
Power
Mains or solar; power over Ethernet for listen-only heads
Network
A fiber ring between nodes, with a mesh radio as backup
Sites
Front-line positions, bases, airports, stadiums and other critical infrastructure

Demo

See it track a drone.

We’ll show you our radar testbed tracking a small drone and walk through how the network would cover your sector. In person in Boulder, Colorado, or over video.

  1. 01

    The testbed

    Our radar nodes, and the drone tracks they have recorded.

  2. 02

    How the network covers a sector

    Where the nodes go, what they see, and what happens when some are lost.

  3. 03

    How tracks would reach your systems

    From a track to the command-and-control systems and effects your unit already runs.

Book a demo

Join us

Want to build this with us?

  • Microwave hardware & antennas
  • Radar signal processing & tracking
  • FPGA & embedded software
Get in touch

Contact

Talk to us

Units, program offices, primes, test ranges, investors and engineers: tell us what you are working on.

* Required